恒流应力下E2PROM隧道氧化层的退化特性研究

在电容测量的基础上研究了薄隧道氧化层在恒定Fowler-Nordheim(F-N)隧穿电流下的退化情况. 这种退化是恒流应力和时间的函数，对恒流应力大小的依赖性更加强烈，隧道氧化层在F-N电流下的退化是注入电荷密度(Q_inj)的函数. 在较低Q_inj下氧化层中发生正电荷俘获，在较高Q_inj下发生负电荷俘获，导致栅压变化的反复. 关键词： 2PROM')" href="#">E²PROM 隧道氧化层 退化 恒流应力     

强激光在窄通道中传播的理论研究

在考虑相对论和有质动力非线性以及全局电量守衡的前提下,分析了强激光在冷等离子体窄通道中稳定传播的情况。采用较为简化的二维理论模型,给出了描述激光和通道横向结构的解,对不同通道宽度、通道密度、激光强度和电磁模式等进行了讨论,分析了其对激光在等离子体通道中传播的影响。分析发现,在存在预通道的情况下,当等离子体通道的密度大于临界密度很多时(例如20倍临界密度),即使是在激光波长量级的通道中,激光仍然可以传播。通道越宽,等离子体密度越小;激光强度越大越容易传播。在同样的通道和传输情况下,TE0模传输所需要的激光强度比TE1模要小。     

一维无序体系电子跳跃导电研究

建立了电子隧穿电导模型,推导了一维无序体系新的直流电导公式.通过计算20000格点无序体系的直流电导率,分析了直流电导率和温度及外场电压的关系,讨论了无序度对直流电导的影响.计算结果表明,无序体系的直流电导率随无序度的增加而减小;外加电场较小时,电导率相对较大,且出现一系列峰值,电压较大时,电导率反而较小;无序体系在低温区出现了负微分电阻特性,电导率随温度的升高而增大,在高温区电导率随温度的升高而减小.计算结果和实验符合很好 关键词： 无序体系 电子隧穿 直流电导率     

4英寸热氧化硅衬底上磁性隧道结的微制备

就如何在4英寸热氧化硅衬底上沉积高质量的磁性隧道结纳米多层薄膜材料和如何利用光刻方法微加工制备均匀性较好的磁性隧道结方面做了初步研究，并对磁性隧 道结的磁电性质及其工作特性进行了初步测量和讨论.利用现有的光刻设备和工艺条 件在4英寸热氧化硅衬底上直接制备出的磁性隧道结，其结电阻与面积的积 矢的绝对误差在10% 以内，隧穿磁电阻的绝对误差在7% 以内，样品的磁性隧道结性质具有较好的均匀性和一致性，可以满足研制磁随机存储器存储单元演示器件的基本要求. 关键词： 磁性隧道结 隧穿磁电阻 磁随机存储器 4英寸热氧化硅衬底     

纳米TiO2的光生电荷迁移特性研究

利用场诱导光电压谱(简称FISPS)和瞬态光伏(简称TPV)技术研究了TiO₂的光生电荷的产生和传输机制.发现光生电荷在体块TiO₂上的迁移机制不同于在纳米TiO₂上的迁移机制，也不同于在结界面空间电荷区的迁移机制. 400 ℃处理的TiO₂颗粒表面具有大量的表面态，光生电荷被表面态捕获-释放机制控制着光伏行为的过程是慢过程. 800 ℃处理的TiO₂已经形成了完整的能带结构，光伏响应除了表现带-带跃迁外,还有一个在带边的自由激子带，光生电荷被表面自建场驱动进行传递的过程是快过程. 600 ℃处理的TiO₂混晶由锐钛矿型和金红石型两种构型组成，在两相之间存在着较低势垒的结界面．它的光伏响应受控于两种机制 ：光生电荷在两相间结界面空间电荷区的传输和在表面自建场驱动下的传输.当激发光强较小时，界面空间电荷区的光生电子由于积累的浓度较小而不能隧穿过结界面，这种场助隧穿只有在外场作用下才能发生.     

Electron beam induced purification of dilute off gases from industrial processes and automobile tunnels

The electron beam process has proved to be an efficient method for the removal of inorganic pollutants from flue gas. Since it simulates natural processes which occur in the atmospheric photochemistry, it appeared attractive to investigate the potential of the e-beam process to clean off-gases which contain hydrocarbon and inorganic trace components. Such emissions arise from industrial processes and from automobile tunnels. Commercial solvents were vaporized in air and irradiated with energetic electrons (300 keV). CO, CO₂ and aerosol particles were found as products and were determined quantitatively. The aerosol particles can be collected by a gravel bed filter and can be removed by combustion or biological degradation. From experiments and model calculations it was found that the e-beam process is a very economic tool to remove hydrocarbons from large off-gas volumes at initial concentrations of 50–100 mg C/m³, and that NO_x can be removed very efficiently from tunnel off-gas.     

Evolution of downsized crescent-shaped dune in wind tunnel experiment

The migration of a downsized crescent-shaped dune was investigated in a wind tunnel experiment.Quantified upwind influx and vertical oscillation of the sand bed were introduced to modulate the saturation level of the sand flux above the dune surface to affect dune evolution.The evolution was recorded by top-view photography and then abstracted as the evolution of self-defined characteristic quantities using a digital image processing algorithm.The results showed that,in contrast to the case for spanwise quantities,the evolution of streamwise quantities corresponds to a linear increase in the modulation magnitude more positively and in a monotonic and convergent manner.In contrast with quantities on the windward face,the changes in quantities with respect to the horns were nonmonotonic with time and almost uncorrelated with the variation in modulation strength,which reveals the distinctiveness of leeside evolution.     

Spin-polarized current and tunnel magnetoresistance in heterogeneous single-barrier magnetic tunnel junctions

Current in heterogeneous tunnel junctions is studied in the framework of the parabolic conduction-band model. The developed model of the electron tunneling takes explicitly into account the difference of effective masses between ferromagnetic and insulating layers and between conduction subbands. Calculations for Fe/MgO/Fe-like structures have shown the essential impact of effective mass differences in regions (constituents) of the structure on the tunnel magnetoresistance of the junction.     

大型砂尘风洞中砂尘浓度测量与控制方法的研究

砂尘浓度指标严重影响砂尘风洞试验效果;在大型砂尘风洞中准确的测量及有效的控制砂尘浓度是砂尘风洞设备研制中的两个关键问题;针对动态试验工况环境中浓度传感器标定的问题,分析了浓度测量时标定参数与风速和浓度的关系,使用模型树算法建立了三者之间的关系模型,以此模型来预测各种动态情况下的标定参数;针对复杂环境下浓度动态控制问题,采用专家PID算法,提出了多回路控制系统结构和专家规则;工程实践表明该测量和控制方法满足了动态试验环境的需求,取得了良好效果;模型树算法和专家PID系统能有效的解决动态工况下砂尘浓度的测量与控制问题。     

Study on the nanoscale current of ZnO film by photoassisted peak force tunnel atomic force: A novel technique for UV detection

ZnO film-based ultraviolet (UV) detector was fabricated by photoassisted peak force tunnel atomic force (PFTUNA) on fluorine tin oxide (FTO) substrate. The PFTUNA current in dark and in UV light was ~0.1 and 2.0 nA, respectively. The UV sensitivity (photocurrent/dark current) is more than 20. The response time and the recovery time are ~0.12 and 0.32 s, respectively. The UV sensing mechanism is that the holes will transport to the ZnO surface to capture the adsorbed oxygen ions to weaken the depletion layer under UV illumination. The PFTUNA current between the tip and the ZnO film is consistent with the Richardson–Schottky (RS) thermionic emission model.